Products categories

4x Alloy Propeller Prop Nut Cap CW CCW for EMAX and DJI Motors

Alloy Propeller Prop Nut Cap for DJI Phantom 2 vision Brushless Motor 2212  920KV(DJI-PTM07), also can work on DJI Phantom V1
With automatic locking feature - See more at:

35A 3-6S XRotor Micro BLHeli ESC

Quality Components
The use of F396 48MHz MCU, imported MOSFETs (Toshiba MOSFETs for
20A ESCs) and ceramic capacitors
3-in-1 drive ICs, 3-ounce copper, 4 layers of PCBs and other quality
components guarantees less heat, higher efficiency, and more rapid response

BLHeli Firmware Ready
Users can flash or upgrade the BLHeli firmware via the signal cable (on ESCs), and program 4 ESCs simultaneously after
connecting their flight controller to the BLHeliSuite software if the flight controller uses the CleanFlight firmware.

Damped Light Mode & OneShot125 Mode Supported
Damped light mode improves the motor retardation and allows
users to break the FPV drones more efficiently. Active-freewheeling
technology improves driving efficiency, flight time and heat
dissipation. The ESCs support OneShot125 high-speed throttle
signal and regular throttle signal (within 500Hz) modes

Twisted-Pair Signal Cable Reduces Interference
The twisted-pair throttle signal cable effectively reduces interference produced in signal
transmission and makes the flight much more stable and reliable.
Applications FOR: FPVs with 150-330mm Diagonal Wheelbase

Cont./Peak Current: 35A
LiPo Cells: 3-6S LiPo
BEC Output: no
Input Wires: Red-18AWG-100mm*1
Output Wires: No wires but solder tabs
Throttle Range Calibration: Supported
Stick Programming: Stick Programming/BLHeliSuite
DEO: Not Supported
OneShot Mode: Supported
Timing: Supported
Light Color: Not Supported
Motor Rotation: Supported
Size: 35 x 17 x 6mm/1.4 x 0.7 x 0.2 inch(just the panel size, not including the cable)
Package size: 173 x 110mm/6.8 x 4.3 inch
Net weight: 23g
Package weight: 30g

FlySky FS FS-R6B 2.4G 6 Channel Receiver

Channels:6 channels 
Model type:car 
Frequency bank :2.4G 
Sensitivity:1024 RF.
Receiver sensitivity:-100dbm 
Weight:5g ANT 
Color:gray semi-transparent cer
For remote control cars

10 OHM 1 % Package size 1206 SMD Resistor(5 Pcs Packet)

Name: SMD Resistor
Quality Grade: Industrial
Manufacture Part no: RC1206FR-0710RL
Manufacture: Yageo 
Package Size: 1206

Datasheet Link:

Male A-USB to DIP Pinboard 4-Pin 2.54 2.54mm



At present, mobile phone charger is everywhere, this module is used to convert the charger or computer USB port for conventional DIP2.54mm pin, a great convenience for your application

Package Included:
1 X Male A-USB to DIP Pinboard

i2c IIC Serial 128X64 (12864) OLED 1.3 Inch Blue LCD Display Module


Size: 1.3
Resolution: 128X64
Color: Blue
Viewing angle: greater than 160 degrees
Supported platforms: for  arduino, 51 series, MSP430 series, STIM32 / 2, SCR chips
Low power consumption: 0.04W during normal operation
Support wide voltage: 3.3V-5V DC
Working temperature: -30-80 degrees
Volume: 27MM * 27MM * 4.1MM
Driver IC: SSD1106
Communication: IIC, only two I / O ports
No font: The software takes word modulo
Backlight: OLED self light, no backlight

VCC: 3.3-5V 
GND: Ground
SCL: Serial Clock
SDA: Serial Data

Package Included:
1 X IIC OLED Moudle

RTR 1/12 Off-Road 45Km/H Speed Fastest Electric RC Monster Truck / Car


A New Category of Off-Road Excitement
2.4GHz Radio System
6CH, forward/backward, left/right turn
Electronic speed control
S-Truck suspension technology for superior handling and control
Powerful GP Brush 390 motor largest in class
Quality and capability you expect from bearing is available in off road performance
Gun type controller
PA material

Item No.: Foxx S911
Description: RC 1/12 Scale Electric racing truggy(PA UPDATE VERSION)
Action time:approx 9-10 minutes
Remote distance:approx 80m
Speed: 45Km/hour, 2-speed
Battery for Controller:2x1.5V AA batteries( not included)
Battery for Car:9.6V 800mAh Rechargeable Lithium-iron battery
Charging Time:2 Hours
Product: 32*26.5*15cm
Box: 37.5*28*18cm

Package include
1 x Foxx S911 Car
1 x Transmitter
1 x All kinds of standard Charger
1 x 9.6V 800mAh Car Battery
1 x Phillips Screwdriver
1 x Hex Wrench
1 x steering wheel
1 x User Manual(English)

Youtube video link:

QRD1114 Reflective Object Sensor

• Phototransistor Output
• No contact surface sensing
• Unfocused for sensing diffused surfaces
• Compact Package
• Daylight filter on sensor